Connect laptop to controller

When the state page of the charger needs to be checked, or the configuration parameters changed, please follow the steps below.

Step-by-step guide

1. Take Micro-USB cable and connect the USB-A connector to your Windows 7 or 10 laptop and the Micro-USB connector to Slave (right hand side) controller
   
   
2. If required, install the RNDIS driver for Windows
3. Open web browser (for example Chrome or FireFox)
4. Load the below web pages depending which controller's state page you want to see
   
   1. If you need to access the Master controller, open page: http://192.168.123.123:81/state
   2. If you need to access the Slave controller, open page: http://192.168.123.123/state
5. Load the below web pages depending which controller's Operator page you want to see
   1. If you need to access the Master controller's Operator page, open page: http://192.168.123.123:81/operator/operator
   2. If you need to access the Slave controller's Operator page, open page: http://192.168.123.123/operator/operator
6. If the web page asks for login credentials, please provide the login credentials

Another possible way to connect laptop to controller

USB-to-Ethernet adapter is needed. It must to be inserted into USB-A connector (in dual sided charger you have to connect the connector in to the controller board you are trying to configure).

From the USB-to-Ethernet adapter the Ethernet cable goes in to the laptop.

1. You will need to change the IP-address of your laptop to static address.
2. For example: (IP-address: 192.168.124.120), (Subnet mask: 255.255.255.0), (Gateway: 192.168.124.1).
3. Open web browser (for example Chrome or FireFox).
4. Open state page: http://192.168.124.123
5. Or open operator page: http://192.168.124.123/operator/operator
6. If the web page asks for login credentials, please provide the login credentials.

Related articles